EBoot_Vybrid - Change Log

0006228: [EBoot] Bad block marker may not initialized correctly

0005485: [EBoot] Add support for inverted LCD_DEN voltage

0005138: [Selftest] Touch controller TSC2004 isn't detected every time

0004810: [NAND-FMD] Flash reading failed -> Too many bad blocks, read exceeds first 16 blocks

0004804: [NAND-FMD] Improved ECC handling

0004777: [NAND-FMD] Improve ECC error handling 0004776: [Selftest] Add support for new touch controller TSC2004

0004331: [EBoot] Using EBoot V1.5 or V1.6 kernel download may not not work under special conditions

0004004: [NAND-FMD] Improve stepstone write routine.

0003315: [EBoot] Writing PSD from EBoot sets all bytes of MAC to 0xff

0002906: [Ethernet] Ignore last nibble of the phy ID

0002499: [EBoot] Enable spread spectrum for PLL1-3

0002374: [EBoot] HW Watchdog is not active 0002378: [Selftest] Add parallel interface test on NetDCUA5 0002422: [Selftest] Add usb-host test 0002376: [Selftest] Calculate test picture to get a correct representation

0002351: [EBoot] PM1.2/PMA5: Lost LAN support in EBoot V1.00

0001965: [EBoot] Enter the bootloader works not reliable while serial debug output is disabled 0002343: [EBoot] add external clock detection for enet phy's

0002305: [Display] Optimize repeated start of LCD controller 0002285: [Display] Add support for 8BPP mode for LCD Display 0002301: [NAND-FMD] NBoot update to higher version is not possible

0002272: [EBoot] After bootloader update flash partitioning doesn't work. 0002185: [EBoot] Add support for Micrel PHY 8081RNA on armStoneA5, NetDCUA5

0002138: [NAND-FMD] Read disturbance handling

0001954: [EBoot] In spite of disabled serial debug output some messages appear on the debug line.

0001947: [EBoot] Don't show NBoot version if it downloaded over EBoot

0001937: [EBoot] Pass LCD settings to Windows CE kernel

0001909: [EBoot] Add support to download nboot via USB 0001893: [F3S] Add F3S support 0001704: [USB device] Add support for USB download with NetDCU USB Loader 0001857: [EBoot] Missing functions to activate the Bootscreen

0001797: [EBoot] Add support for NBOOT_V003 and newer 0001802: [EBoot] Add support for hardware watchdog 0001791: [EBoot] Enable L1 cache

0001696: [NAND-FMD] Add support for NAND FMD 0001695: [Ethernet] Add support for Ethernet