PicoCoreMX8MM_HW - Change Log

0006034: [MISC] Remove connection between RESETIn and CPU_POR_B (R124) 0004616: [MISC] Board crash because of RTC 0004477: [MISC] Remove R73 0004478: [MISC] R70 needs to be connected to USB_OTG_PWR 0004479: [MISC] Add Pull-Down resistors for USB_OTG_PWR 0004481: [MISC] Add serial resistor for GPIO_J1_52 and GPIO_J1_54 for QSPI option 0004482: [MISC] Add serial resistor for AUDIO_A_GND 0004483: [MISC] Add mounting option for SAI1_RXFS and SAI1_RXC 0004484: [MISC] Route WLAN_LED to Pin ETH_B_LED 0004485: [MISC] Change Testpoints for WLAN 0004467: [MISC] Missing Testpoints 0004466: [MISC] Missing pull-up on SD_B_WP Pin 0004465: [MISC] Missing pull-up on SD_B_CD Pin 0004460: [MISC] False voltage level on PMIC I2C 0004388: [MISC] False condition of LVDS_STBY Pin 0004387: [MISC] False voltage level on LVDS chip 0004389: [MISC] Change the RTC Chip

0004355: [MISC] Optional Pull Down for USB_HOST_PWRn Pin 0004341: [MISC] UART_A CTS and RTS pins are connected false 0004339: [MISC] I2C Signals of the A71CH are connected reverse.

0004139: [MISC] Voltage breaks down when booting uboot 0004180: [MISC] Mount only R125 or R126. 0004076: [MISC] The signal RESETINn has no pull up resistor t 3.3V. 0004105: [MISC] Booting Problem 0004104: [MISC] Missing pull-up on SD_B_RST Pin 0004103: [MISC] False Voltage level on USB_VBUS Pins 0003983: [MISC] Wrong connection of WDOG reset pin 0003904: [MISC] Wrong I2C for PMIC 0003840: [MISC] Missing pull up for NAND_RB0 Signal 0003838: [Ethernet] Ethernet MDIO signals are reversed. 0003554: [MISC] Power Audio Codec form internal 3.3V 0003905: [MISC] Missing connection of "P1V35_DDR3_SW3" 0004075: [MISC] R39 and R38 are both placed on the board. This leads to a short circuit and the board does not boot. 0004034: [MISC] Change MIPI to LVDS 0003930: [MISC] Check capacitors on 24M oscillator 0003575: [MISC] "+V3.3S" is not connected to 3.3V 0003665: [WLAN] Change mountig for 24MHz 0003664: [MISC] Get RTCCLK from PMIC